0203 886 0138184 Shepherd’s Bush Road, London W6 7NL

Maintaining Your Home's Plumbing System in Hammersmith

Plumbing is not the most exciting part of owning a home, but it is one that matters. Clean water in, waste water out, it all runs quietly until something goes wrong. A bit of know-how goes a long way. This guide covers the basics for Hammersmith homeowners, so you can spot problems early and know what you can handle yourself.

The hard water here is worth a mention up front. West London is a hard-water area, and Thames Water classes the local supply as hard. That limescale works away at pipes, fittings and anything that heats water, so it shapes a lot of what goes wrong in local homes.

Know your pipes

Your plumbing is two systems. Supply pipes bring clean water in under pressure. Waste pipes carry it away. Knowing roughly where they run, and where the stopcock is, makes everything easier when something leaks. Find your internal stopcock now, before you need it, usually under the kitchen sink. In older Hammersmith homes the stopcock can be stiff or seized from years of limescale, so give it a gentle turn to free it off. If it will not budge, do not force it. In a converted flat, check you also know where the shared mains stopcock is for the building.

Spotting leaks

Leaks cause damage and waste water, and the small ones are the worst because they hide. Watch for damp patches, flaky plaster, a musty smell, mould in a corner, or a water bill that has crept up for no reason. A quick test: turn everything off and look at the water meter. If the dial is still moving, water is going somewhere. WaterSafe recommend this meter check as the first step if you suspect a leak, see their guide to detecting a water leak. Older Hammersmith houses often still have their original copper, and hard water causes pinhole corrosion in copper over the years, usually at bends and fittings.

Where leaks tend to hide

If the meter says you have a leak but nothing is dripping in plain sight, these are the usual spots:

Where to checkWhat you are looking for
Under sinks and behind the washing machineWeeping compression fittings and worn hoses
Around the boiler and under radiatorsRust marks, damp carpet, a slow drip at a valve
Ceilings below a bathroomSpreading stains from a pipe or seal above
Walls on original copper pipeworkPinhole corrosion at hidden bends and joints

Tackling blockages

Blocked waste is a regular one. Reach for a plunger first, not a chemical cleaner, the chemicals are harsh on older pipework and rarely shift a proper blockage. A drain snake clears most sink and shower traps. For anything that keeps coming back, leave it and get it looked at properly, because a repeat blockage usually means something further down the line.

Maintaining your plumbing

A bit of upkeep saves money. Check under sinks and around the boiler now and then for damp. Lag exposed pipes in the loft and garage before winter so they do not freeze and burst. In a hard-water area like Hammersmith, a scale inhibitor on the boiler and a water softener are worth considering, they cut the limescale that furs up heat exchangers and blocks fittings. A yearly once-over by a plumber catches corrosion and weeping joints before they flood a ceiling.

DIY fixes

Some jobs are well within reach. A dripping tap is often just a worn washer or cartridge. A running toilet is usually the flapper or fill valve. Both are cheap parts and a steady afternoon. Just turn off the water at the stopcock or the isolation valve before you start, and have a towel ready. If you open something up and it is more corroded than you expected, common on old Hammersmith pipework, stop and call someone.

Conclusion

Knowing the basics of your plumbing saves a lot of grief. Find your stopcock, keep an eye out for damp and a creeping bill, and tackle the small jobs with the water off. Hard water does its quiet damage in Hammersmith, so a scale inhibitor and the odd check go a long way, especially in older W6 and W14 homes on original copper.

When a leak hides or a fitting fails, that is where the right kit comes in. If your bill has jumped or you have unexplained damp, see our leak detection page or call us to book a survey.

Plumbing Issue?

Get In Touch 24/7!

Use our contact form to get a call back from us

0203 886 0138

REQUEST A CALLBACK